When you have children, swing sets are an excellent addition to the backyard environment.
Adults, too, can have a lot of fun on a swing set, especially with the right seats.
However, you must first assemble it.
Kit for swing brackets
How far apart should swing brackets be spaced?
How much space should there be between chains?
These are the questions you must address before proceeding, and with regards to the swing brackets, the optimal safe distance between swing brackets is 18″. You can cut this down to 16″ if you need an extra swing, but the US Consumer Product Safety Commission says that 18″ to 20″ is the best range.
You’re probably thinking that those figures fluctuate quite a bit. The truth is that anything between 16″ and 18″ will suffice.
The CPSC will always err on the side of caution to the point of impracticality.
The distance between swing brackets
That is not to say they are incorrect, as the reasoning is motivated by the safety of children.
However, most swings do not maintain a full 20″ between swing brackets, unless they are in state parks.
Always adhere to the manufacturer’s installation instructions when installing any equipment.
What Should the Width of the swing brackets be?
Swing seats should be approximately 17″ to 18″ long, 8″ wide, and have a minimum of a 1″ dip without any weight on them.
If you’re installing a swing for the first time, you’ll want to mount your swing brackets in the manner described above, taking into account the width of the seat.
It would look ridiculous if the chains were too close together and the seat was too long.
Bear in mind that the seat will bulge downward whenever you, another person, or a child sits in it, so you don’t want the chains to touch your ears when you sit.
Is Beam Length Determined by Swing Bracket Distance?
The length of the beam will be determined by the distance between the swing brackets that you choose.
That is, unless you have a pre-cut beam.
In this case, the beam’s length will dictate the spacing between the swing brackets.
If you want to go 24″ between swing brackets, the CPSC recommends 24″ between swing seats and an additional 30″ between a swing seat and the swing set’s foundation, which may include supporting beams and other structures.
If you’re building your own swing set, you’ll need to determine the number of swings that will fit on a single beam.
If you want more than three swings, you’ll almost certainly need to add a middle support beam to separate two sets of two swings.
Naturally, you’ll also need to account for the 30″ distance between the swings and the middle support beams.
Depending on how many swings you want, you may need a long beam to hold them all up.
How Are Your Swing Brackets Spaced?
Acquiring the proper amount of space and being precise with your measurements is critical, even more so if you’re working with a pre-cut beam.
You want to get as many swings on there as possible without jeopardizing safety.
Usually, the main beam that holds the swings will be about two feet longer than the last support beam on the outside.
Correctly install swing brackets.
Swing structures are usually made up of things like: a slide ladder, a playhouse, and more. It will hit them in the other direction.
To begin with, you’ll want to determine the total length of the beam.
From here, you can figure out how many swings you can put in between load-bearing beams that go down from the main beam.
You must allow 30″ between the structure and any additional load-bearing beams.
Then install the brackets along the beam, leaving a gap of 16″ to 20″ between the swing brackets and swings.
While some websites recommend 8″ between swings, if you have very young children, accidents are more likely to occur the closer the swings are together.
With a 12′ beam, you can easily install three swings with an 18″ to 20″ spacing between the swing brackets and a 20″ spacing between each swing.
If you wish to add a fourth swing, lengthen the beam by 4 ‘to make it an even 16’. What Kind of Space Should Be Allowed Around the Swings?
The distance between the bottom of the swing and the ground should be approximately 12″ for very young children, increasing by 4″ every few years.
Spacing between swing brackets
As a bonus, you can dig channels under each swing, which is a common thing to do at playgrounds and parks.
If you want to get the most out of your swing set in terms of children growing until they are no longer able to play on it, there should be a minimum of 6′ of empty space all the way around the swing, with a 6′ deck height.
If you have kids, a swing set is a great thing to buy. Assembling your own is probably easier than you think.
As long as the distances are considered, you’ll end up with a nice swing set that the kids will enjoy for years.